Heian Shindo Draw A Line | Tension Rod
The Draw A Line tension rods are available in three sizes: A, B and C. The tension rods A and B can be installed horizontally and vertically. The tension rod C is only suited for a vertical set up between ceiling and floor.
An intelligent spring-mechanism makes Draw A Line easy to install, no nails, screws or tools required. First you measure the distance between the walls, than you choose a tension rod that will work with your space. The measured distance must fall within the size range of the chosen rod. Then you place the tension rod between the opposing walls and adjust the length by turning the brass-screw. Continue lengthening until the entire rod sits tight. Then fix the position by turning the locking knob.
The Draw A Line tension rods are available in black or white. They are made of steel with a durable epoxy powder coating. The adjusting screw is made of steel with a brass finish.
You will find these complements for the Draw-A-Line-tension-rod-system in our shop:
Draw A Line Shelf A and Shelf B (suitable for tension rod A und B if installed horizontally)
Draw A Line Hook A (suitable for tension rod C, also A and B if installed vertically)
Draw A Line Table A (suitable for tension rod C, also A and B if installed vertically)
|Size (h x Ø) in cm||75 - 115 x Ø 7 | 115 - 190 x Ø 7 | 200 - 275 x Ø 7|
Tension rod A: 75 - 115 x Ø 7cm
Tension rod B: 115 - 190 x Ø 7cm
Tension rod C: 200 - 275 x Ø 7cm
Pole: Steel / Matte epoxy powder coating
Adjusting screw: Brass / steel / ABS
Stapler Needle: Stainless steel
Tension rod A: 15-25kg horizontal / 10 kg vertical
Tension rod B: 5-15kg horizontal / 10 kg vertical
Tension rod C: 10 kg vertical
|Weight in kg||1.5|